Covers the female end of chimney pipes for a decorative effect. Finished in a sleek black Designed to fit through a wall thimble or be suspended from a roof support system. For use with DuraTech pipes that are 10" in diameter. A venting pipe with an inner diameter of 10" is required for this unit. To produce a stylish and finished effect, use this DuraTech All-Fuel Chimney Pipe Finishing Collar on the female end of DuraTech chimney pipe. Designed to fit through a wall thimble or be suspended from a roof support system. Large diameter 10" to 24" DuraTech chimney pipe is designed for appliances that are tested and listed for use with a 1700 degrees Fahrenheit rated chimney system such as zero-clearance or masonry fireplaces, furnaces, boilers, water heaters, ranges, or other appliances fueled by oil, coal, gas, or wood. UL 103 certified and MH 7399 listed. Galvalume (GA) and stainless steel (SS) exterior walls and stainless steel inner walls are both available. Screws are required for installation. 10" to 24" in diameter, depending on the application. DuraTech is an all-fuel chimney system with a 1" wall that may be used with wood stoves, fireplaces, furnaces, boilers, ranges, water heaters, and other appliances that run on wood, coal, or gas. Made of 027" 430 stainless steel inner wall and outer wall of .029" galvalume or .027" 430 stainless steel. Between the walls is a Thermal Tech (ceramic refractory) blanket insulation. The pipe is sealed with stainless steel end rings. c-UL-us Listed to UL 103 and ULC S604 (MH7399) In Canada, a stainless steel exterior wall is necessary for installation. DuraVent Item Number: 10DT-FC

Creates a decorative look by covering the female end of chimney pipes Sleek black finish Designed for pipe suspended with a roof support system or passing through a wall thimble For use with 10" DuraTech pipes